13
Remove the baffle plates from both sides
of the base (by removing the plate on the
left side as an example).
Remove the baffle pieces from the back
of the base.
All the three cable holes on the base can be used for
cable layout, depending on the actual requirements.
10
Moving the Cabinet onto the Base
b
Install the lifting lugs.
Tie the ropes.
Store the plastic screws properly.
Maximum 90°
Plastic
screw
Lifting lug
Move the cabinet onto the base.
Remove the ropes and install the plastic screws.
Before installing the plastic screws, clean the installation holes to ensure that they are free of metal
shavings.
Select a proper method to move the cabinet as required. The crane is here used as an example.
NOTE
NOTE
CAUTION
CAUTION
To Next Page
Loading...
