Huawei OptiX RTN 910A - Installing AC Power Cables; APM30 H Cabinet AC Input Power

22
Connecting the Input Power Cable for the APM30H Cabinet
a
2
Installing and Routing the Power Cables – AC Power Supply
AC power
box cover
AC protecting
cap
Use a Phillips screwdriver to remove an M3 screw from the AC input protective cap, and open the protective cap.
Tighten the AC input protective cap.
Route the power cables into the cabinet along the inner left side of the cabinet, connect each wire to the
corresponding terminal, and use a torque screwdriver to tighten the screws.
The short-circuiting bar does not need to be removed when single-phase 220 V power is
input. The short-circuiting bar must be removed when three-phase 220 V power is input.
NOTE