28
4
Installing the Service Cables for the Equipment – AC Power
Supply
Installing E1 Cables
a
Installing Ethernet Cables
b
For cabinet sharing, the E1 cables need not be connected to the SLPU.
Instead, they are directly connected to the equipment at the opposite end.
APM30H/TMC11H Ver.C and earlier versions use rubber blocks to lead out
cables, and APM30H/TMC11H Ver.D and later versions use cable bags to
lead out cables.
NOTE
E1 cables for 1xAnea
96/4xDB25 conversion
are used.
For cabinet sharing, the Ethernet cables are not connected to the SLPU.
Instead, they are directly connected to the equipment at the opposite end.
APM30H/TMC11H Ver.C and earlier versions use rubber blocks to lead
out cables, and APM30H/TMC11H Ver.D and later versions use cable
bags to lead out cables.
NOTE
To Next Page
Loading...
