Need help?Do you have a question about the Huawei SUN2000-12KTL-M1 and is the answer not in the manual?
General| Max. DC Voltage | 1100 V |
|---|---|
| Input Voltage Range | 200 V - 1000 V |
| Start Voltage | 200 V |
| Number of MPP Trackers | 2 |
| Efficiency | 98.6% |
| Rated AC Frequency | 50 Hz / 60 Hz |
| Adjustable Power Factor Range | 0.8 leading - 0.8 lagging |
| Max. Total Harmonic Distortion | <3% |
| DC Reverse Polarity Protection | Yes |
| AC Overcurrent Protection | Yes |
| AC Short-Circuit Protection | Yes |
| DC Insulation Resistance Detection | Yes |
| Residual Current Monitoring | Yes |
| AC Overvoltage Protection | Yes |
| Protection Class | IP65 |
| Cooling | Natural Convection |
| Rated Output Power | 12000 W |
| Rated AC Power | 12000 W |
| Max. Apparent AC Power | 13200 VA |
| Surge Protection | DC Type II / AC Type III |
| Operating Temperature Range | -25 °C ~ +60 °C |
| Relative Humidity (Operating) | 0 %RH~100 %RH |
| Operating Altitude | 4, 000 m |
| Communication | RS485 |
| Maximum Output Power | 13200 W |
| Display | LED |
Specifies physical and environmental conditions for inverter installation.
Step-by-step guide for mounting the inverter onto the bracket.
Instructions for connecting the protective earth (PE) cable to the inverter.
Guide on assembling and connecting DC input power cables to the inverter.
Instructions for configuring the physical layout of PV optimizers in the system.
Guide to configuring battery control and charge/discharge parameters.
To Next Page