28
Click
Positive metal terminal
Negative metal terminal
Ensure that the cable
cannot be pulled out after
being crimped.
Positive connector
Negative
connector
Use the wrench
shown in the figure to
tighten the locking
nut. When the wrench
slips during the
tightening, the
locking nut has been
tightened.
Ensure that cable
polarities are correct.
PV-CZM-22100/19100 (Staubli)
PV-MS-HZ open-
end wrench
(Staubli)
DC input terminals
•
If the original DC input power cables are not long enough, add DC input extension cables.
•
(Optional) installing battery cables, assemble the positive and negative connectors by
following the instructions in section "Installing DC Input Power Cables."
Assembling DC Connectors
Installing DC Input Power Cables
Click
Pull the DC input power cables back to
ensure that they are connected securely.
Extension cables for DC terminals
Battery terminals (BAT+/BAT–)
To Next Page
Loading...
