11
5. Place the cable entry cabinet on the right of
the UPS cabinet.
6. Install the front and rear connecting kits.
7. (Optional) Secure the cable entry cabinet to
the ground.
8. Install an equipotential plate.
9. Remove a certain number of small covers
from the bottom of the cable entry cabinet
based on site conditions.
10.Remove the signal cable trough cover from
the cable entry cabinet.
If the cable entry cabinet is
placed on the left of the UPS
cabinet, remove the cable
trough for signal cables and
install it on the right of the
cable entry cabinet.
To Next Page
Loading...
