Cable Connection
Connect cables according to Figure 2-2 and power on the device. As device does
not provide a power switch, it starts up immediately after receiving power. When
the SYS indicator on the frontpanel is blinking (once every two seconds), the
device is running and ready for conguration.
Figure 2-2 Connecting cables of USG6510E, USG6530E
After the power cable is installed, adjust the cable-retention clip to an appropriate position,
use a cable-retention clip to bundle the cable of the power adapter, and adjust the cable-
retention clip to fasten the cable.
HUAWEI USG6000E Series Quick Start 2 Device Introduction and Cable Connection
Issue 02 (2022-08-22) Copyright © Huawei Technologies Co., Ltd. 6
To Next Page
Loading...
