QUICK START
Installation & Programming Guide
www.hubbell-automation.com
PRECAUTIONS
• READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
• CAUTION - RISK OF ELECTRICAL SHOCK. To prevent electrical shock, turn off power at the circuit breaker before
installing or servicing unit. Never wire energized electrical components.
• NOTICE: For installation by a licensed electrician in accordance with National and/or local Electrical Codes and the
following instructions.
• CAUTION: USE COPPER CONDUCTOR ONLY.
• Be sure to read and understand all instructions before installing or servicing unit
• For Indoor use only. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Disconnect switch or a circuit breaker must be provided and marked as the disconnecting device.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Confirm that device ratings are suitable for application prior to installation.
• No user serviceable parts contained inside unit. Refer all service related questions to the factory. All servicing shall be
performed by qualified service personnel.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
• Use only approved materials and components (i.e. twist on connectors, electrical box, etc.) as appropriate for installation.
• NOTICE: Do not install if product appears to be damaged.
• If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be
impaired.
• Do not use this equipment for other than intended use.
3226A 08.13.2014
To Next Page
Need help?
General
