Huck AK-175 - RIVET PINTAIL REMOVAL; THREE PIECE JAW INSTALLATION AND REMOVAL; TWO PIECE JAW SYSTEM; THREE PIECE JAW SYSTEM

8






        








 
  












Once Rivet is installed, pintail must be removed
1. Point tool downward
2. Squeeze RELEASING TRIGGER “B”.
Rivet Pintail Removal:
The jaws are installed at the factory and should only need to be removed for periodic inspection and cleaning. To
remove the jaws unscrew the NOSE TUBE from the tool in a counterclockwise direction
Three/Two Piece Jaw Installation and Removal:
Pintail reMoval and three Piece Jaw
inStallation and reMoval
CAUTION: It is necessary to remove pintail
before attempting to install another rivet.
AK-175 Series Tools (HK1057) Arconic Fastening Systems and Rings