O W N E R' S M A N U A L 15
Generator
The front and rear bearings of the genera-
tor are also provided with oilers (A) and (B),
Figure 4, and should be lubricated with
engine oil every 1,000 miles. Do not over-
lubricate.
Water Pump
To prevent excessive gun pressures
from damaging the self-adjusting oil seal,
a metered lubrication fitting (A), Figure 5,
is provided on the water pump.
Lubricate the water pump through this
fitting every 1,000 miles with a high-
grade aluminum soap base lubricant until
excess lubricant flows out through open-
ing at top of fitting.
Throttle Linkage
Lubricate throttle linkage, Figure 6,
every 1,000 miles with engine oil to in-
sure freedom of movement.
To Next Page
Loading...
Need help?
General
