Need help?Do you have a question about the Hudson 1957 and is the answer not in the manual?
General| Brand | Hudson |
|---|---|
| Model | 1957 |
| Category | Automobile |
| Language | English |
Key engine performance and dimensional specifications.
Detailed specifications for intake and exhaust valves.
Specifications for piston and ring clearances and dimensions.
Specifications for crankshaft and bearing dimensions and torques.
Specifications for camshaft end play and bearing clearance.
Details on oil pump, pressure, and capacity.
Key tune-up parameters like timing, points, and spark plugs.
Description and adjustment of the Delco-Remy distributor.
Procedure for replacing distributor contact sets.
Guidance on inspecting and testing the distributor.
Methods for adjusting the distributor dwell angle.
Specifications for the vehicle's battery.
Specifications for the vehicle's generator.
Specifications for voltage and current regulators.
Specifications for the starting motor.
Specifications for the solenoid switch.
Detailed specifications for the distributor.
Specifications for spark plugs.
Chart listing bulb types and their locations.
Introduction to the Carter WCFB carburetor.
Explanation of the float circuits in the carburetor.
Description of the low-speed metering circuit.
Description of the high-speed metering circuit.
Description of the accelerator pump circuit.
Explanation of the choke control circuit.
Procedures for carburetor overhaul and adjustments.
Steps for assembling the carburetor body.
Steps for assembling the air horn.
General section for carburetor adjustments.
Detailed specifications for various carburetor components.
Specifications for clutch springs.
Adjustment of clutch levers.
Adjustment of clutch pedal linkage free play.
Lubrication of the clutch linkage.
How the overdrive unit functions.
Overview of overdrive electrical circuits.
Troubleshooting common overdrive issues.
Procedure for removing the transmission.
Steps for disassembling the transmission.
Detailed explanation of overdrive operation.
Explanation of the electrical circuits for overdrive.
Description of the governor circuit's function.
Description of the solenoid circuit.
Description of the kickdown circuit.
How the circuits interact during operation.
How to inspect governor operation.
Steps for disassembling the transmission and overdrive.
Procedure for removing torque tube and seal adapter.
How to disengage the shift shaft.
Procedure for removing governor and solenoid.
Procedure for removing the overdrive case.
Procedure for removing speedometer/governor gears.
Procedure for removing cam and pinion cage.
Procedure for removing sun gear/shifter rail assembly.
Procedure for removing cover plate, hub, and pawl.
Guidelines for inspecting transmission parts.
General guidelines for reassembling the transmission.
Lubrication requirements for transmission and overdrive.
Service procedures for standard/overdrive transmission shifting.
Service procedures for Hydra-Matic transmission shifting.
Adjusting the selector lever linkage.
Specifications for brake system components.
Specifications for wheels and tires.
Procedure for adjusting pinion depth.
Specifications for rear springs.
Detailed specifications for the rear axle.
Procedure for removing front springs.
Information on steering gear stops.
Details on steering knuckle pin and spindle.
Specifications for front wheel alignment.
Specifications for front springs.
Exterior and interior paint color codes.
Interior color options.
Lubrication points in the engine compartment.
Lubrication points under the chassis.
Transmission fluid level check.
Cooling system lubrication/checks.
To Next Page
