4
CAUTION: Changes or modi cations
to this unit not expressly approved by the
party responsible for compliance could
void the user’s authority to operate the
equipment.
This device (charger/adapter) complies with
Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment o and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit di erent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Radio Frequency Information (charger/adapter)
Safety & Warnings
WARNING:
ALWAYS WEAR YOUR
HELMET WHEN RIDING
THIS PRODUCT!
• Helmet should sit level on your head and low on your
forehead. Exposed forehead can result in serious injury.
• Adjust the strap sliders below the ear on both sides.
• Buckle the chin strap. Adjust strap until it is snug.
• No more than two ngers should t between the strap
and your chin.
• A proper tting helmet should be comfortable and not
rock forward/backward or side to side.
Helmet Warning Information
17
Troubleshooting Guide - continued
Vehicle will not
run when Switch is
pressed.
Poor contact of wires or
connectors
Check that the battery connectors
are rmly plugged into each other. If
wires are loose around the motor call
Customer Service.
“Dead Spot” on motor A dead spot means the electric power
is not being delivered to the terminal
connection and the vehicle needs
repair. Call Customer Service.
Loud grinding or
clicking noises
coming from motor
or gear box
Motor or gears are dam-
aged
Call Customer Service.
Drive Wheel is partially
engaged
Check drive wheel - to motor engage-
ment.
Battery will not
recharge
Battery connector or
adapter connector is
loose
Check that the battery connectors are
rmly plugged into each other.
Charger not plugged in
Charger is not working Check that the battery charger is
plugged into a working wall outlet.
Battery is dead Replace battery.
Charger feels warm
when recharging
This is normal and not a
cause for concern
If excessively hot, unplug and replace.
Problem Possible Cause Solution
Troubleshooting Bubble Blower:
Not producing
Bubbles:
Power Switch OFF Ensure Power Switch is ON
Bubble Solution empty Fill Bubble Solution Tray
Bubble Outlet clogged Clean Outlet with water and cotton
swab
Run clear water through Bubble Solu-
tion Tray until system is clean.
Bubble Motor not run-
ning.
Contact Customer Service.
SEE OPERATION SECTION FOR OPERATING INSTRUCTIONS
Problem Possible Cause Solution
Troubleshooting
To Next Page
Loading...
Need help?
General
