8
Assembly
Tools Needed (supplied)
Allen/Phillips Wrenches
Introduction to Assembly
This Owner’s Manual may be made for several di erent style products.
• Some illustrations may vary slightly from the actual product.
• Follow instructions completely.
• If the product has any parts that are not described in this manual, look for separate
“Special Instructions” that are supplied with the unit.
• All features, components and accessories are not included on all models.
• Use the Index page to locate speci c sections of this manual.
• Please read through this entire manual before beginning assembly or maintenance.
• If you are not con dent with assembling this unit, contact customer service.
WARNING: Keep small parts away from children during assembly.
NOTE: All of the directions (right, left, front, rear, etc.) in this manual are as seen by the
rider while seated.
Do not dispose of the carton and packaging until you complete the assembly of the
product. This can prevent accidentally discarding parts of the unit.
CHARGING PORT LOCATION:
NOTE: Charging Port
A
is located on the
front LEFT side of the deck, next to the
Bubble ON/OFF switch
B
.
B
A
T-Axle Wrenches (x2)
13
Maintenance Repair and Service
General: The vehicle should be checked for
damage, missing or badly worn parts before
each use. If any part of the product does not
operate properly – discontinue use.
• Check the tightness of the fasteners before
each use. Replace any fasteners that are
damaged.
• Inspect the product frequently. Failure to
inspect the product and to make repairs
or adjustments, as necessary, can result in
injury to the rider or to others. Make sure all
parts are correctly assembled and adjusted
as written in this manual and any “Special
Instructions”.
• Immediately replace any damaged, missing,
or badly worn parts.
• Make sure all fasteners are correctly tight-
ened as written in this manual and any
“Special Instructions”. Parts that are not
tight enough can be lost or operate poorly.
Over tightened parts can be damaged.
Make sure any replacement fasteners are
the correct size and type.
• Check the tightness of the wheels:
Note: If the drive wheel is not tight, it will not
engage the gears and the vehicle will not run.
• Ensure the battery bracket is securely in
place before use.
• Store the vehicle indoors. Keep it away from
sources of heat, such as stoves and heaters.
• Keep the product clean and free of dirt,
dust and water. This will prolong the useful
life of the product.
• Clean the vehicle with a soft, dry cloth. To
restore shine to plastic parts, use a non-wax
furniture polish. Do not use automotive
wax, abrasive cleaners or wash the vehicle
with soap and water.
WARNING: Water will damage
the motor, electrical system and battery.
NOTE: If the instructions in this manual or any
“Special Instructions” are not su cient for
you, please contact customer service.
Maintenance
To Next Page
Loading...
Need help?
General
