2.7 Technical description:
Transmitter
Transmission frequency: 2,4 GHz
Battery: CR2032 (Lithium 3V)
Control unit
Supply voltage: 12V – 24V DC
Power: max. 30 watts
Connections: 4 x Out 2pol. 12V – 24V DC
2.6 Programming another transmitter
If the remote control unit has been set to a dierent transmission frequency for the
customer in the described manner and you would like to have another hand transmitter
which fulfils the same functions as the first one, the transmission frequency for the extra
transmitter must also be altered.
Now press the and OFF ( O ) buttons until the LED control lamp stops blinking.
Release both buttons.
Slow bright blinking begins.
! Within 5 seconds the OFF ( O ) button must be pressed for a short time (ca. 1 second). !
Then actual frequency selection takes place as described above in section 2.5 (frequency
selection). Please ensure that the same frequency (1 – 4) is set for the extra remote cont-
rol unit as for the existing transmitters.
Caution!
The order of the necessary steps to be taken is dierent from those described under
section 2.5.
Bedienungsanleitung_Farblichtsteuerung_Druck.indd 17 13.10.15 16:08
To Next Page
Loading...