Humaneyes 3D 360 VR CAMERA - Before Using Your Camera; Power On; Off; Operation Modes; Capture Media

Operation
Proprietary. Humaneyes Technologies 11
Operation
Before Using Your Camera
Before you use your camera, make sure it is fully charged and the internal clock is synced with the Vuze
Camera App. Please follow the recommendations below:
• The camera should be fully charged before use. Make sure you charge it about 3 hours.
• The camera has an internal clock. This clock affects the time-stamp on the footage captured. Your time
zone will be automatically updated when the Camera is connected to your mobile device through the
Vuze Camera App. To ensure the correct time zone connect your camera to the Vuze Camera App as
instructed below.
Power On / Off
• On – Press the On/Off button. You will hear 3 beeps and the indication light will blink.
• Off - Press the On/Off button for 2 seconds. You will hear 3 beeps and the indication light will blink.
Operation Modes
You can use the camera for recording videos and for taking photos.
The LED color of the On/Off button indicates the operation mode, as follows:
Video Mode
Photo Mode
To change between modes press the On/Off button. Two beeps will confirm the change and the On/Off
button will blink twice and change color
.
Capture
•
Start / Stop Video – Press Capture button (in Video Mode). You will hear a single beep when
beginning and two beeps when ending a recording.
•
Take a Photo – Press Capture button (in Photo mode). You will hear a single beep before and after
and the indication light will blink once.
When switching between operation modes the camera must be in standby mode.