After-Manufacture “Rustproofing”
Your vehicle was designed and built to resist corrosion.
Application of additional rust-inhibiting materials is
neither necessary nor required under the Sheet Metal
Coverage. GM makes no recommendation concerning
the usefulness or value of such products.
Application of after-manufacture rustproofing products
may create an environment which reduces the corrosion
resistance built into your vehicle. Repairs to correct
damage caused by such applications are not covered
under your GM New Vehicle Limited Warranty.
Paint, Trim and Appearance Items
Defects in paint, trim, upholstery or other appearance
items are normally corrected during new vehicle
preparation. If you find any paint or appearance
concerns, advise your dealer as soon as possible.
Your owner’s manual has instructions regarding the
care of paint, trim, upholstery, glass, and other
appearance items.
Chemical Paint Spotting
Some weather and atmospheric conditions can create a
chemical fallout. Airborne pollutants can fall upon and
attack painted surfaces on your vehicle. This damage
can take two forms: blotchy, ringlet-shaped
discolorations, and small irregular dark spots etched into
the paint surface.
Although no defect in the factory applied paint causes
this, HUMMER will repair, at no charge to the owner, the
painted surfaces of new vehicles damaged by this
fallout condition within 12 months or 12,000 miles of
purchase, whichever comes first.
Warranty Coverage – Extensions
Time Extensions: The New Vehicle Limited Warranty
will be extended one day for each day beyond the
first 24 hour period in which your vehicle is at an
authorized dealer facility for warranty service. You may
be asked to show the repair orders to verify the
period of time the warranty is to be extended. Your
extension rights may vary depending on state law.
9
To Next Page
Loading...
Need help?
General
