Hunter Stoves HERALD 6 User Manual

HERALD 6
GAS STOVE
Installation and Servicing
Instructions
Please leave this instruction booklet with the user after the installation is
complete. Leave the system ready for operation and instruct the user in the
correct use of the appliance and operation of its controls.
Please refer to the appliance data plate for the specific model type.

Hunter Stoves HERALD 6 Specifications

General

Category	Stove
Model	HERALD 6
Heat Output	6kW
Efficiency	78%
Fuel Type	Wood
Flue Diameter	125mm
Weight	85 kg

Summary

Technical Data

Stove Dimensions

Diagrams illustrating the physical dimensions of the stove.

Installing the Appliance

Pre-Installation Notes

Essential checks and requirements before beginning the installation of the gas stove.

Installation Site Requirements

Guidance on selecting a suitable and safe location for the stove installation.

Opening Clearances

Specifies required safety distances for installing the appliance in an opening.

Flue Arrangement

Additional Air Venting (GB Only)

Removing the Stove Body

Removing the Cast Iron Doors

Step-by-step instructions for safely removing the stove's cast iron doors.

Removing the Stove Body

Detailed procedure for detaching the main body of the stove.

Removing the Glass

Instructions on how to safely remove the glass panel from the stove.

Gas Supply Connections

Testing Supply Pressure

Installing the Fire-Bed

Fire-Bed Arrangement

Overview of the two types of fire-bed arrangements: coal effect and log effect.

Fitting Coal Effect Ceramic Matrices

Fitting Loose Ceramic Coals

Fitting Log Effect Ceramic Matrices

Fitting Loose Ceramic Logs

Re-assembling the Stove

Fitting the Canopy (Optional)

Test for Spillage

Spillage Monitoring System

Operating the Appliance

Fitting the Remote Control (Optional)

Fitting the Motor to the Valve

Detailed steps for attaching the motor component to the gas valve.

Attaching the Remote Control Receiver Box

Servicing Instructions

Spares List