Hunter 20171 - Operating Remote Control and Mounting Holder

16
42683-01 • 09/11/09 • Hunter Fan Company
10-1. Do not install the battery into the remote control until after you
set the jumpers.
10-2. e remote transmitter has individual buttons for turning the fan
o and on and controlling the light and fan speed.
10-3. For best operation, start the fan by pressing high, then select your
desired speed.
10-4. e light button turns the light on to full brightness. To dim the
light, hold the light button down until you reach your desired
brightness. Push the light button again to turn o the light.
10-5. e reversing switch reverses the direction of the fan.
10-6. Press the OFF button to turn the fan o.
10-7. When necessary, replace the battery with a 12-volt type 23A,
MN-21 battery or equivalent. Please contact your local battery
recycling center for proper battery disposal information.
10-8. You can mount the remote holder to any toggle switch plate with
the screws already in the switch plate. Or, you can simply mount
the remote holder on the wall.
Step 10-6
Fan Light
Fan Speed
High
Fan Speed
Medium
Fan Speed
Low
Fan O
Reversing Switch
Steps 10-1 – 10-5
Step 10-7
10 • Operating the Remote Control and Mounting the Holder