Hunter 21317 - Installing the Glass Bowl

15
45032-01 • 01/21/11 • Hunter Fan Company
7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Installing the Glass Bowl
7-8. First install candelabra bulbs (60 Watt Maximum) into the sockets.
7-9. If the fandangle is attached to the extra pull chain, remove it now.
7-10. read the fan pull chain through the hole in the metal disc. en,
thread the fan pull chain through the hole in the center of the glass
bowl.
7-11. read the light pull chain through the hole in the center of the
glass bowl. en, read the light pull chain through the hole in
the center of the cover plate.
7-12. read the fan pull chain through the grommet hole in the side of
the cover plate.
7-13. Place the cover plate up against the glass bowl. Align the holes in
the cover plate and glass bowl.
7-14. read the light pull chain through
the nial and screw the nial onto the
threaded rod end until tight.
7-15. Reattach the fandangle to the extra
pull chain.
Light Bulb
Sockets
(60 Watt
Maximum)
Metal Rod
Metal Disc
Glass Bowl
Cover Plate
Finial
Breakaway
Connector