18
45032-01 • 01/21/11 • Hunter Fan Company
Problem: Nothing happens; fan does not move.
1. Turn power on, replace fuse, or reset breaker.
2. Loosen canopy, check all connections according to the wiring the fan section.
3. Check the plug connection in the switch housing.
4. Push motor reversing switch rmly left or right to ensure that the switch is engaged.
5. Pull the pull chain to ensure it is on.
6. Remove the shipping bumpers.
Problem: Noisy operation.
1. Tighten the blade assembly screws and blade iron armature screws until snug.
2. Check to see if the blade is cracked. If so, replace all the blades.
Problem: Excessive wobbling.
1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to balance the fan.
2. Tighten all blade iron screws.
3. Turn power o, support fan very carefully, and check that the hanger ball is properly seated.
Problem: CFL bulbs flicker when controlled by a dimming remote or wall control
1. CFL light bulbs are not usually made for dimming. Replace the CFL bulbs with dimmable light bulbs, or
install the fan in a location without a dimming control.
In compliance with U.S. Federal regulations, this ceiling fan contains a wattage saver that limits the
light output to 190 Watts. e following issue may arise if total wattage exceeds the wattage limit
marked on the MAX wattage sticker affixed to the light socket(s):
Issue: Lights shut off suddenly, but fan is still operating
1. Check to make sure the wattage and type of the light
bulbs that are installed meet the specications on the
light socket.
2. Turn the power to the fan o at the wall switch. Wait
5 minutes, then resume power to the fan.
If you need parts or service assistance, please call
888-830-1326 (In Canada, call 1-866-268-1936) or
visit us at our Web site at
http://www.hunterfan.com.
Hunter Fan Company
7130 Goodlett Farms Pkwy. #400
Memphis, Tennessee 38016
9 • Troubleshooting
To Previous Page
Loading...
