HUNTER
4. To prevent corrosion inside the
cylinders, pour a little lubricating oil into
the suction pipe while turning the engine.
Enough oil to reach the intake/exhaust
valves is sufficient.
5.Put the piston at top dead center of
compression stroke so that the intake/ex-
haust valves are completely closed.
6.
Apply a thin anti-corrosion treat-
ment to the plating and exposed painted
surfaces.
7.
The engine should be in a well-
ventilated area, and protected from any
kind of dampness.
8.
Put a dust cover over the engine.
9.
Check your operation manual for
engine diagram and for
MANUFAC-
TURERS RECOMMENDED
WINTERIZING PROCEDURES.
To Next Page
Loading...
