Hunter 30445 - Using Your Air Purifier; Initial Setup

44114-01 • 03/06/2012
6
Figure 4
Figure 5
Figure 2
Using Your Air Purifier
Your air purifier was thoroughly inspected and tested at
the factory prior to packaging. Visually inspect it upon
removal from its box. Remove and discard any packaging
material. Return the unit if it shows any signs of damage
or mishandling.
INITIAL SETUP:
Figure 3
Figure 1
Pre-lter
Lower Tabs
Lower Notches
Arrow
1. Take the air purier out of the box and remove the
clear plastic protective bag and place the unit on a
rm, level surface.
2. Before turning on the air purier, you need to conrm
that the lters are rmly in place and have not
become loose during shipping.
3. Remove the rear grill on the back of the unit by
gently pulling the removal tabs away from the unit
and lift the rear grill away. Figure 1.
4. The washable pre-lter is mounted inside the rear
grill of the unit. Conrm that it properly covers the
grill vents. Figure 2.
5. The HEPA lter will be resting inside the unit. If
present, remove the plastic bag surrounding the
lter and place the lter back into the air purier.
The lter should have an arrow on the side to
indicate air ow and the direction the lter should
be placed back into the unit. The arrow should
point toward the front of the unit. Figure 3.
6. The lter tab on the lower right side of the lter ,
ts into the lter notch to ensure that the lter is
installed in the correct position. Figure 4.
7. Set the lower tabs on the bottom of the rear grill into
the lower notches (gure 5) in the base of the unit
and rock the rear grill up until the top tabs snap into
place. Figure 1.
8. Plug the unit into a 120V electrical outlet.
Rear Grill
Filter Tab
Filter Notch
Filter
Rear Grill
Removal Tab
Top Tab