Hunter 30710 - Filter Replacement Process; Filter Replacement and Reset Procedure

41780-01 12
Air Purier Maintenance
FILTER
To change the lter and reset the Filter Life Counter:
1. First, turn o and unplug the air purier.
2. Next, remove the front grill. Place your ngers under the handle on the grill
and pull forward, then up. Refer to Figs. 4 and 5 (pg. 6).
3. Gently pull on the lter to remove it from the unit. While removing the lter,
note the directional arrows printed on the top of the lter. The new lter will
be installed with the same orientation. Refer to Fig. 10. Once removed, the
used lter can be discarded.
4. Look at the directional arrows printed on the side of the lter. Install the lter
with arrows pointing towards the unit. Refer to Fig. 10. Press the lter rmly
into the air purier. To avoid damaging the lter media, you should press on
the frame of the lter only.
5. Place the front grill back onto the unit. First, line up the tab on the bottom
of the grill with the recess on the purier base and then push the top of the
grill forward until it is closed. Refer to Figs. 6 and 7, pg. 7. NOTE: This unit will
not operate unless the grill is in the correct position.
6. Plug in the unit.
7. To reset the counter to zero hours and turn o the indicator, simply press
and hold the FILTER RESET key for three seconds. Then, you must release the
reset key and then press and hold the lter reset key again for three seconds
to turn o the lter indicator.
Fig. 10