Hunter 30710 - Initial Operation; Basic Air Purifier Setup

41780-01 6
Operation
Initial Operation
This section provides basic instructions on the use of your air purier. After following these
initial directions, please continue reading this booklet to learn how to operate the more
advanced features of your air purier.
Basic Operation of the Air Purier:
1. Take the air purier out of the box and remove the clear plastic protective
bag. Place the unit on a rm level oor.
2. Before turning on the air purier, you need to conrm that the lters are rmly
in place and have not become loose during shipping. To check the lters, rst
open the front grill. Release the front grill by placing your ngers under the
handle on the grill and pull forward, then up. Refer to Figs. 4 and 5.
Fig. 4
Fig. 5
3. Next, check the HEPAtech
®
lter by pressing rmly on all four corners of the
lter to ensure that it is fully inserted into the lter opening.
4. The carbon pre-lter is mounted inside the front grill with hook tape. Conrm
that it properly covers the grill vents. You may notice a few black particles
coming o the pre-lter. Those particles are part of the odor-removing acti-
vated carbon and will be collected on the lter during use.
HANDLE
PULL
FORWARD,
THEN UP