45C
4268045C
NONE
SAIL COVER ONLY OFFERED ON STANDARD MAST BOATS
TIE THE AFT END OF THE SAIL COVER UP TO THE TOPPING LIFT LINE USING THE PIECE OF STRING PROVIDED 7 . USE HALF
HITCH KNOTS TO SECURE THE COVER IN PLACE AT THE OUTER END OF THE BOOM. THE REEF LINES RUN OUT THROUGH
THE COVER SLOTS 8 AND TIE OFF.
FEED THE LAZYJACK LINES 4 DOWN THROUGH THE GROMMETS/RINGS 5 IN THE SAIL COVER, STARTING AT THE TOP AND
COMING OUT AT THE BOTTOM OF THE COVER. DEAD END THE LINES TO THE BAILS ON THE UNDERSIDE OF THE BOOM 6 .
SLIDE THE BOLTROPE ON THE TWO HALVES OF THE COVER INTO THE BOLTROPE TRACKS 1 ON BOTH SIDES OF THE BOOM.
START FROM THE AFT END AND MAKE YOUR WAY FORWARD.
INSTALL THE PVC BATTENS 2 INTO EACH HALF OF THE SAIL COVER. THERE ARE POCKETS 3, THAT OPEN TOWARDS THE
FRONT, ON THE INSIDE OF THE COVER. SLIDE THE BATTENS INTO PLACE FROM THE FRONT, AND ROLL THE INSIDE LIP OF
THE POCKET BACK IN ORDER TO HOLD THE BATTENS STATIONARY.
1
7
4
6
8
6
5 5
2
6
5
MAST STEP
MAST
3
STRUTS
SAIL COVER
To Next Page
Loading...
