Hunter 51059 - Fan Wiring; Single Switch Wiring Guide; Dual Switch Wiring Guide

3
4
1886
1886
Installing the Ceiling Bracket
LPPC-01 r092421
Have dual switches?
Follow these steps:
We know wiring is hard. Let’s make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route be-
low that best matches your wall switch setup. If you are unfamiliar with wiring or
uncomfortable doing it yourself, please contact a quali ed electrician.
Have a single switch?
Follow these steps:
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Wiring the Fan
x4
bag
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Connect the black wire
(ungrounded) from the
ceiling to the black and the
blue wires from the fan.
Black
Blue
White
Ungrounded
Grounded
Grounding
G
r
e
e
n
/
Y
e
l
l
o
w
S
t
r
i
p
e
G
r
e
e
n
/
Y
e
l
l
o
w
S
t
r
i
p
e
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
Connect the
black wire
(ungrounded)
from the ceiling
to the black wire
from the fan.
Black
Blue
White
Ungrounded
Grounded
Grounding
G
r
e
e
n
/
Y
e
l
l
o
w
S
t
r
i
p
e
G
r
e
e
n
/
Y
e
l
l
o
w
S
t
r
i
p
e
Connect the second
ungrounded (light)
wire from the
ceiling to the blue
wire from the fan.
Ungrounded (light)
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming
from the ceiling and
hanging bracket.
Wire Nut
x4
bag
Wire Nut
WARNING
The ceiling fan must be grounded. If the
ground wire for the installation site is not
present, immediately STOP installation and
consult a quali ed electrician.
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a quali ed electrician.
Have extra wiring?
Turn the wires upward and push them carefully back
through the hanger bracket into the outlet box. Spread
the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other
side of the outlet box. Make sure that the wires are still
attached to the wire nuts.
Hunter Pro Tip:
Fan style may vary.
Note:
Ceiling Bracket Hanging Fan Wiring Motor Housing Blades Switch Housing