www.HunterFan.com
1.888.830.1326
Hunter Fan Company
13
Troubleshooting
Excessive wobbling
Tighten all of the blade and
blade iron screws until they
are snug.
Use the provided balancing
kit and instructions to balance
the fan.
Noisy Operation
Tighten the blade and blade
iron screws until they are snug.
Check to see if any of the
blades are cracked. If so, replace
all of the blades.
Fan doesn’t work
Make sure power switch is on.
Pull the pull chain to make sure
it is on.
Push the motor reversing switch
it is engaged.
Check the circuit breaker to
ensure the power is turned on.
Make sure the blades spin freely.
Turn off power from the circuit
breaker, then loosen the canopy
and check all the connections
according to the wiring diagram
on page 7.
Check the plug connection in
the switch housing.
To Previous Page
Loading...
