Hunter Antero 52128 - Installation: Fan Body, Canopy, and Blades; Connect Wiring Harness; Jumper Harness Installation; Install Snap-on Canopy

7 6
Installation – Canopy Mount and Terminal Wiring (continued)
Installation – Fan Body, Wiring Harness, Canopy Cover, and Blades
Connect wiring harness from canopy mount (A) to wiring harness
from fan body (C).
2b
A
C
B
Install snap-on canopy (B) over downrod on fan body (C). Place the down
rod ball into the slot in canopy mount (A) with built-in ceiling bracket.
2a
1
2
A
B
C
B
NOTICE
To prevent damage to fan, ALWAYS lift holding either the
fan housing or the downrod.
Slide the snap-on canopy (B)
over the canopy mount (A) until
it clicks in place.
2c
B
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
Install a snap-on blade to pop locks on pre-installed blade iron.
Repeat for remaining blades (E).
2d
C
D
2
x5
1
IMPORTANT
Note: Follow the instructions on the blade.
Installing it incorrectly could result in your
fan not functioning.
IMPORTANT
Note: For single switch wiring an additional
jumper harness component will be needed.
Take the jumper harness (H) from the
accessories bag. Connect the female end
to the hanging bracket connector. Connect
the male end of the jumper harness to the
ceiling fan connector.
H
E