Hunter Argenus 30987 - Troubleshooting; Problems and Solutions; Obtaining Replacement Main Filters; Technical Support

Troubleshooting
43006-01 12
Problem Solutions
Obtaining Replacement Main Filters
ToobtainreplacementMainFiltersforyourAirSterilizer,rstdetermineyourmodel
number by looking at the information label on the back of the Air Sterilizer. The model
number will be listed on the label. Then, call 1-800-4HUNTER for your nearest retailer
or Hunter Customer Service at 1-888-830-1326 (CAN 1-866-268-1936). To ensure
youobtainthecorrectlters,pleasendyourmodelnumberbelowthatspeciesthe
correctreplacementlters.
Hunter Air Sterilizer Model No.: .................... 30580, 30581, 30582
Replacement Main Filter No.: ....................... 30987
CADR:............................................................300
Recommended Room Size:..........................21 x 22
1. Unit does not
operate.
4. Unit has reduced air
ow or increased
noise.
5. Fault Indicator is on.
• Conrmthattheunitispluggedin.
• ChecktheinstallationofthePre-Filter,theMain
Filter, and the Top Cover. (See pgs. 8, 9, & 10.)
• ResettheAirSterilizer.(SeeResettingtheAir
Sterilizer, pg. 11.)
• ChecktheinstallationofthePre-Filter,theMain
Filter, and the Top Cover. (See pgs. 8, 9, & 10.)
• ThePre-Filterand/orMainFilterLifeCounterhas
reached the estimated usage times. Check and
clean the Pre-Filter and/or replace the Main Filter
if needed. (See pgs. 7 - 10.)
• ThePre-Filterand/ortheMainFiltermaybe
excessively dirty. Check and clean the Pre-Filter
and/or replace the Main Filter if needed. (See
pgs. 7 - 10.)
• ChecktheinstallationofthePre-Filter,theMain
Filter, and the Top Cover. (See pgs. 8, 9, & 10.)
• ResettheAirSterilizer.(SeeResettingtheAir
Sterilizer, pg. 11.)
• IftheFaultIndicatorremainsonafterresetting
the Air Sterilizer, turn the unit off and contact
Hunter Technical Support.
• ThePre-Filterand/ortheMainFiltermaybe
excessively dirty. Check and clean the Pre-Filter
and/or replace the Main Filter if needed. (See
pgs. 7 - 10.)
2. Unusual noise; pop-
ping, sizzling, etc.
3. Pre-Filter and/or
Main Filter indicator
is on.