7
8
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Installing the Bulbs and Glass
ON
Turn Power
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Connect 9-pin to the plug
connector found in the
switch housing area of
the light kit assembly.
Make sure to line up the
colored markings on the
connectors.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
2 of 3
Light Kit Screw
bag
Fan style may vary.
Note:
Fan style may vary.
Note:
3 of 3
bag
Connect the single-pin connectors from the light kit to
the connectors from the fan. Connect the white wires
together. Connect the blue and black wires together.
Make sure all the wires from the fan and the light kit
are snug inside the center of the light kit, not pinched
in between the upper switch housing and the light kit or
hanging out of the sides.
Install the three switch housing screws, found
in the hardware bag . Tighten all three
screws.
Insert the third screw, found in the
hardware bag, into place and then
tighten all three screws.
1 of 3
Light Kit Screw
bag
Short Light
Kit Screw
To Next Page
Loading...
Need help?
General