Hunter Bayview - Light Kit and Pull Chain Assembly; Light Kit Assembly Steps; Pull Chain Installation

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Control
Canopy Screw
Installing the Pull Chain
ON
Turn Power
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs and click “How do I install my
fan with light kit?”
Hunter Pro Tip:
Fan style may vary.
Note:
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Lift the lower switch housing until its screw
holes are aligned with the screw holes in
the upper switch housing. Install the three
switch housing screws, found in the
hardware bag. Tighten all three screws.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert a third screw, found in the
hardware bag, into place and
then tighten all three screws.
1 of 3
3 of 3
Assembly
Screw
Light Kit Screw
bag
bag
2 of 3
Assembly Screw
bag
1
STEP
4
STEP
5
STEP
2
STEP
3
STEP
Assembling the Light
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Fan style may vary.
Note:
Feed the pull chains from the fan
switch down through the hole in the
upper switch housing as shown.
Attach the pull chain pendants to
the fan pull chains.
The fan pull chain controls
the speed: from high to off.