Hunter EcoSilver HP450UV - Warranty

Cleaning & Maintenance
CHECK AND CLEAN:
Note: This guide covers several air purier models. Your model may have some or all
of the features listed.
CLEANING EXTERIOR:
Clean unit with a moistened soft cloth only. DO NOT pour or splash water on the unit
or use any abrasive-type cleaner on it. Clean all external surfaces, especially the air
intake grills and air outlet.
NOTE: Ensure the air purier is completely dry before plugging into power
outlet and turn ON. Failure to do so could cause damage to the lters or air
purier.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shot.
WARNING
USING THE CONTROLS
Power: Press the center On/O button to turn air purier on or o.
Accent Light: Press the accent light button to turn the light on and o.
Speed/Sleep: Press the Speed/Sleep button to select Low, Medium, High or Sleep
Mode. Low provides the best product sound. Medium oers moderate cleaning. High
provides strong cleaning power. Sleep Mode operates on Low until mode is manually
changed.
Timer: Press the Timer button to select from 2, 4, or 8 hour timer settings.
Filter Indicator: Press the Filter Indicator button to reset once the pre-lter and/or
HEPA lter have been replaced. See instructions on resetting light below.
UV Mode: UV Mode removes airborne bacteria. When UV Mode is activated by
pressing the UV Mode button, the air purier accent light will turn on. The accent
light is NOT the UVC light, only an indicator that UV Mode is on. UVC light is
enclosed in the unit to avoid exposure or harm. Accent light cannot be
turned o in UV Mode.
7
Cleaning & Maintenance
RESETTING FILTER TIME INDICATOR
HEPA Filter Indicator Light: Your Hunter
®
air purier is programmed to remind you to
replace the HEPA lter after 6 months, based on continuous use (approximately 4,320
hours). This indicator is only a guide. Depending on air quality and environmental
factors, HEPA lter may need to be replaced more regularly. After lter is replaced,
press and hold the HEPA lter indicator button for 3 seconds. The unit will beep 3
times to indicate reset.