The air purier is operated by the soft touch controls located on the top of the air
purier. This manual covers several dierent models. The air purier you have
purchased may have some or all of the features listed.
USING THE CONTROLS
Power: Press the center On/O button to turn air purier on or o.
Accent Light: Press the accent light button to turn the light on and o.
Speed/Sleep: Press the Speed/Sleep button to select Low, Medium, High or Sleep
Mode. Low provides the best product sound. Medium oers moderate cleaning. High
provides strong cleaning power. Sleep Mode operates on Low until mode is manually
changed.
Timer: Press the Timer button to select from 2, 4, or 8 hour timer settings.
Filter Indicator: Press the Filter Indicator button to reset once the pre-lter and/or
HEPA lter have been replaced. See instructions on resetting light below.
UV Mode: UV Mode removes airborne bacteria. When UV Mode is activated by
pressing the UV Mode button, the air purier accent light will turn on. The accent
light is NOT the UVC light, only an indicator that UV Mode is on. UVC light is
enclosed in the unit to avoid exposure or harm. Accent light cannot be
turned o in UV Mode.
Operating Your Air Purier
6
RESETTING FILTER TIME INDICATOR
HEPA Filter Indicator Light: Your Hunter
®
air purier is programmed to remind you to
replace the HEPA lter after 6 months, based on continuous use (approximately 4,320
hours). This indicator is only a guide. Depending on air quality and environmental
factors, HEPA lter may need to be replaced more regularly. After lter is replaced,
press and hold the HEPA lter indicator button for 3 seconds. The unit will beep 3
times to indicate reset.
UV Mode
Speed/Sleep
On/O
Timer
Filter Indicator