11 10
Turn Power ON, breaker and main switch.
Installation - Final
ON
ON
OFF
ON
OFF
OFF OFF
ONONON
OFF
The remote control is already paired for use. For your convenience a remote function card is packed in with your remote.
Operation – Remote
NOTICE
• Always purchase the
correct size and grade of
battery most suitable for
the intended use.
• Replace all batteries of a
set at the same time.
• Clean the battery contacts
and also those of the
device prior to battery
installation.
• Ensure the batteries are
installed correctly with
regard to polarity (+ and -).
• Remove batteries from
equipment which is not to
be used for an extended
period of time.
• Remove used batteries
promptly.
Battery Door
Remote Function Guide
Fan On/Off+ Quick Press
Light Dimming+ Long Press
Light On/Off+ Quick Press
Raise Fan
Speed
Lower Fan
Speed
+ Quick Press
+ Quick Press
Key Press Function
Dimming Mode
On/Off
+
Long Press
Long Press
Long Press
Fan High
Fan Low
Fan Reverse+ Long Press
Enable Beep
Disable Beep
+
+
Long Press
Long Press
Install two AAA batteries, found in the remote control hardware bag, into the transmitter. Clean the battery contacts prior to installing the batteries. Please contact your local battery
recycling center for proper battery disposal information.
To Next Page
Loading...
