DOG TRAINING COLLAR WITH GPS TRACKER
MODELS: GPS-DTR 15000-15002-15003 (GPS and training function)
GPS 15000-15002-15003 (no training functioning)
CONTENTS
The following items are included in the package, as shown on the photo below:
dog training collar(s), USB charger(s), USB wire(s), USB adapter(s), long probes pair(s).
PREPARING THE DOG TRAINING COLLAR WITH REMOTE FOR FIRST TIME USE
The dog training collar should be charged for 5-6 hours. A fully charged battery provides an autonomy of 20 hours. Connect the small USB
adapter to the USB wire, and the USB wire to the USB charger. Then, connect the charger to the dog training collar as shown on the photos
below. Lift the yellow rubber protective cover, and connect the charger. Now, switch on the dog training collar.
To switch it on, hold for 1 second the antenna part of the remote (where the built-in magnet is) at the point where the indication light of the
dog training collar is. Then, remove the remote. This way, the red indication light of the dog training collar is constantly ON for few seconds
then is turn o, showing that the device is charging.
After 5-6 hours of charging, remove the charger. Then, switch o the dog training collar, by holding the antenna part of the remote for 4
seconds (where the built-in magnet is) at the point where the indication light of the dog training collar is.
The remote should be charged for 4-5 hours. Connect the charger to the remote as shown on the photo below.
PAIRING AND USE OF THE DOG TRAINING COLLAR WITH REMOTE
The dog training collar(s) sent to you is already paired with the remote.
In case that you need to pair it again, do the following:
The remote can control up to 3 dog training collars.
The remote has 3 pairs of buttons (pair 1, pair 2, pair 3).
Firstly, switch on the remote from the ON/OFF switch. Secondly, switch on the dog training collar. When
the dog training collar is switched on, the indication light of the collar starts ashing.
Thirdly, hold the antenna part of the remote for 10 seconds (where the built-in magnet is) at the point
where the indication light of the dog training collar is. Remove the remote from the collar after 10
seconds and press the corresponding button (TONE button and SET button in same time) of the pair you
wish the dog training collar to be saved. Then, a beep tone is heard, indicating successful pairing. Repeat
the same procedure in case you have other collars.
When pressing the TONE button on the remote, a tone command is sent to the corresponding dog training collar.
When pressing the TONE&SHOCK button on the remote, a tone along with a SHOCK command (stimulation) is sent to the corresponding
dog training collar.
To Next Page
Need help?
General
