EasyManua.ls Logo

Hunter H356 - Glossary of Sailing Terms

Hunter H356
145 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GLOSSARY OF SAILING TERMS
PAGE
5
A
Aback: describes a sail when the wind
strikes it on the lee side.
Abaft: towards the boats stern.
Abeam: at right angles to the center-
line of the boat.
Aft: at or near the stern.
Amidships: the center of the boat,
athwartships and fore and aft.
Anti-fouling: a poisonous paint
compound used to protect the
underwater part of a hull from marine
growths.
Apparent wind: The direction and
speed of the wind felt by the crew. It
is a combination of true wind and that
created by the movement of the boat.
Astern: behind the boat; to go astern
is to drive the boat in reverse.
Athwartships: at right angles to the
fore and aft line of the boat.
B
Back: when a wind backs, it shifts
anticlockwise.
Back a sail: to sheet it to windward
so that the wind fills on the side that
is normally to leeward.
Backstay: a stay that supports the
mast from aft and prevents its forward
movement.
Ballast: extra weight, usually lead or
iron, placed low in the boat or
externally on the keel to provide
stability.
Ballast keel: a mass of ballast bolted
to the keel to increase stability and
prevent a keel boat from capsizing.
Batten: a light, flexible strip fed into a
batten pocket at the leech of the sail
to support the roach.
Beam: 1, the maximum breadth of a
boat; 2, a transverse member that
supports the deck; 3, on the beam
means that an object is at right
angles to the centerline.
Bear away: to steer the boat away
from the wind.
Bearing: the direction of an object
from an observer, measured in
degrees true or magnetic.
Beat: to sail a zigzag course towards
the wind, close-hauled on alternate
tacks.
Delay: to make fast a rope around a
cleat, usually with a figure-of-eight
knot.
Bend: 1, to secure a sail to a spar
before hoisting; 2, to moor a boat; 3,
a sleeping place on board.
Bight: a bend or loop in a rope.
Bilge: the lower, round part inside the
hull where the water collects.
Block: a pulley in a wooden or plastic
case, consisting of a sheave around
which a rope runs. It is used to
change the direction of pull.
Boot-topping: a narrow colored
stripe painted between the bottom
paint and the topside enamel.
Bottlescrew: see Rigging screw.
Broach: when a boat running
downwind slews broadside to the
wind and heels dangerously. It is
caused by heavy following seas or
helmsmans error.
Broad reach: the point of sailing
between a beam reach and a run,
when the wind blows over a quarter.
Bulkhead: a partition wall in a boat
normally fitted athwartships
C
Caulk: to make the seams between
wooden planks watertight by filling
with cotton, oakum or a compound.
Cavitation: the formation of a vacuum
around a propeller, causing a loss in
efficiency.
Center-board: a board lowered
through a slot in the keel to reduce
leeway.
Center-line: center of the boat in a
fore and aft line.
Center of effort (COE): the point at
which all the forces acting on the sails
are concentrated.
Center of lateral resistance (CLR):
the underwater center of pressure
about which a boat pivots when
changing course.
Chain pawl: a short lug which drops
into a toothed rack to prevent the
anchor chain running back.
Chain plate: a metal plate bolted to
the boat to which the shrouds or
backstays are attached.
Chart datum: reference level on a
chart below which the tide is unlikely
to fall. Soundings are given below
chart datum. The datum level varies
according to country and area.
Chine: the line where the bottom of
the hull meets the side at an angle.
Cleat: a wooden, metal or plastic
fitting around which rope is secured.
Clevis pin: a locking pin through
which a split ring is passed to prevent
accidental withdraw.
Clew: the after, lower center of a sail
where the foot and leech meet.
Close-hauled: the point of sailing
closest to the wind; see also beat.
Close reach: the point of sailing
between close-hauled and a beam
reach, when the wind blows forward of
the beam.
Close-winded: describes a boat able
to sail very close to the wind.
Coaming: the raised structure
surrounding a hatch, cockpit, etc.,
which prevents water entering.
Cotter pin: soft, metal pin folded back
on itself to form an eye.
Course: the direction in which a
vessel is steered, usually given in
degrees; true, magnetic or compass.
Cringle: 1, a rope loop, found at
either end of a line of reef points; 2, an
eye in a sail.
D
Dead run: running with the wind
blowing exactly aft, in line with the
center-line.
Deviation: the difference between the
direction indicated by the compass
needle and the magnetic meridian;
caused by object aboard.
Displacement: 1, the weight of water
displaced by a boat is equal to the
weight of the boat; 2, a displacement
hull is one that displaces its own
weight in water and is only supported
by buoyancy, as opposed to a
planning hull which can exceed its
hull, or displacement, speed.
Downhaul: a rope fitted to pull down
a sail or spar.
Draft: the vertical distance from the
waterline to the lowest point of the
keel.
Drag: 1, an anchor drags when it fails
to hole; 2, the force of wind on the
sails, or water on the hull, which
impedes the boats progress.

Related product manuals