Hunter Hepburn - Installing the Wall Plate; Power On and Remote Pairing

www.HunterFan.com
1.888.830.1326
17
The remote transmitter is already paired to the
receiver and ready to use. If you need to pair your
remote, cycle power to the fan by turning power off
and back on at the wall switch (or circuit breaker if
necessary). Within three minutes, do the following:
Reference the included remote function card for
information on how to use your wall control!
Use the pull-chain switch on the fan to set
the fan speed to the HIGH position before
operation.
Turning on the power
ON
Turn Power
IMPORTANT
6
7
8
5
Installing the Wall Plate
Install the shorter screws through
the wall control plate and into the
screw holes in the wall control.
Wall Control (continued)
M3641-01 • 12/20/16 • © 2016 Hunter Fan Company