Hunter Malden - Remote Control Preparation; Remote Battery and Function Guide

9
1886
1886
Ceiling Bracket Hanging FanDownrod Wiring Blades Switch Housing Remote
Preparing the Remote
Phillips
Head
Screw
Battery
Door
To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
ON
Turn Power
Remote Function Guide
Fan On/Off
Low Speed
Medium Speed
High Speed
+ Quick Press
+ Quick Press
+ Quick Press
+ Quick Press
Key Press Function
MA578-01