Hunter Omega - Time Lapse; Timer1; Timer2; Remote Control

Example: Camera will wait 5 minutes between photos/
videos if pre-set time interval is 00:05:00.
Configurable delay time: 00:00:03~23:59:59.
Note! Do not turn ON Time Lapse and Delay
simultaneously!
Time Lapse
Select “ON”, press “OK” to set the time interval.
Camera will take photos/videos automatically upon the
set time interval. Object motion can still trigger the
camera to take photos/videos if PIR Switch is ON.
Configurable interval: 00:00:05~23:59:59.
Note! Do not turn ON Time Lapse and Delay
simultaneously!
Timer1
Select “ON”, press “OK” to set the beginning time and
end time (hour/minute). Camera will only work during
the set time.
i.e.: 06:00 – 10:00; camera only works during 06:00 –
10:00
Timer2
Select “ON”, press “OK” to set the beginning time and
end time (hour/minute). Camera will only work during
the set time.
i.e.: 15:00 – 18:00; camera only works during 15:00 –
18:00
Remote
Control
OFF – Remote control is disabled.
ON-Instant – Remote control is enabled and in stand-
by all the time. Remote commands sent from the APP
(including “Take photo now”) will take effect
immediately.
Caution! This setting depletes the batteries very
quickly, we advise you to use external power supply or
12V/ 2A DC adapter!
ON-0.5H – ON-24H – Remote control is enabled, and
requests sent from the APP will be executed upon
next motion trigger; otherwise camera execute
commands based on the time interval setup (every
0.5hr, 1hr, 2hrs, 3hrs, 4hrs, 6hrs, 12hrs or 24hrs)
Recommended setting to reduce battery consumption!
Other
Setting
Programmable Options