7
8
Ceiling Bracket Downrod Hanging FanWiring Canopy Blades Light Glass/Bulbs
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
ON
Turn Power
Press the globe and globe
keeper ush against the metal
plate. Thread the light pull chain
through the hole in the center of
the nial cap and thread the fan
pull chain through the hole in the
side of the cap. Finally, thread
only the light pull chain through
the hole in the nial and screw
the nial onto the threaded rod.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x2
Fan style may vary.
Note:
Install the last light kit screw.
Tighten all three screws securely.
1 of 3
Light Kit Screw
bag
Partially install two of the switch housing
screws found in the bag.
1
STEP
Align the notches in the sides of the
lower switch housing with the upper
switch housing screws. Lift the lower
switch housing. Twist the lower switch
housing clockwise to lock into place.
3
STEP
4
STEP
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Repeat x5
2 of 3
Light Kit Screw
bag
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
2
STEP
To Next Page
Loading...
Need help?
General