7
Troubleshooting
Problem:
Excessive noise
Solution:
• Check the Water Tank to make sure it is properly seated on
the Base.
• Check the Water Tank to make sure there are no bubbles when
the Water Tank is full and running. If there are bubbles, turn
the unit OFF until the bubbling stops. When the bubbling has
stopped, set the unit to the desired speed.
Problem:
Solution:
• Make sure the unit is plugged in and Adjustment Knob is set to ON
and the indicator light in the base is illuminated.
Problem:
Solution:
• Make sure Water Tank has water in it.
• Clean Water Float. Refer to the “Cleaning” section on page 5.
Problem:
White dust or mineral build-up on the unit
Solution:
• Refer to the “Cleaning” section on page 5.
Problem:
Humidity output and water usage decreased
Solution:
• Check the Adjustment Knob to make sure it is set to the desired
humidity level and speed.
• Check the Water Tank to make sure there are no bubbles when
the Water Tank is full and running. If there are bubbles, turn
the unit OFF until the bubbling stops. When the bubbling has
stopped, set the unit to the desired speed.
• Clean any components that have mineral build-up. Refer to the
“Cleaning” section on page 5.
• Check the Fan Vent and remove any obstructions.
Problem:
Solution:
•
• Be sure to perform regular maintenance.
20304-01 R20150420
To Next Page
Loading...
Need help?
General
