After beads have been seated, disconnect inflation hose
and reinstall valve stem core previously removed. Re-con-
nect the inflation hose and inflate tire to the specified tar-
get pressure. Disconnect the inflation hose.
2.9.1. Blast Inflator
With the inflation hose still connected, lift the bottom side-
wall of the tire. Quickly and firmly press the blast inflator
nozzle against the rim edge.
After beads have been seated, disconnect inflation hose
and reinstall valve stem core previously removed. Re-con-
nect the inflation hose and inflate tire to the specified tar-
get pressure. Disconnect the inflation hose.
2.10. Unclamping
From the procedure wheel slide-out menu, touch “Un-
clamp” or press the right “GO” side of the pedal. Depress
the button on the top of the clamp and remove the clamp
from the rim. Lower the wheel lift by pressing and holding
down the left side of the pedal. Release the pedal when
the wheel assembly contacts the ground.
3. Maintenance and Calibration
3.1. Maintenance Schedule
CAUTION
Do not hose down or power wash the
tire changer
.
Daily
: Turn the tire changer power off at the end of the
work day. At a minimum, depress the emergency stop
switch. Never leave a wheel assembly on the tire changer
overnight. Always remove all assemblies and ensure tools
are returned to their home position. Check for worn or
damaged rubber and nylon components that should be re-
placed to prevent damage from occurring. Replace worn
parts as needed (rubber pads and blocks, rollers, and
mount/demount head). Clean all areas that contact rims or
tires to prevent possible scratching to rim.
Weekly: Clean the tire changer with shop towels or a vac-
uum cleaner. Do not clean with or use compressed air,
which can blast dirt between moving parts. Do not use
cleaning solvents to clean pressure regulator/oiler.
Annually: Change hydraulic fluid and filter once per year.
Contact your Hunter Service Representative for this serv-
ice.
Periodically: Check for loose bolts and tighten per speci-
fications. Contact your Hunter Service Representative for
information.
3.2. End User License Agreement
Use of equipment and it’s operating software is acknowl-
edgment of agreement to the terms of the End User Li-
censing Agreement (“EULA”). The entire EULA can be
found by scanning the QR Code below
.
3.3. Parts Warranty Summary
Hunter Engineering Company warrants new equipment to
be free from defects in material and workmanship under
normal conditions of use for a period of one (1) year from
the date of installation. Exceptions to this warranty are lis-
ted below
.
• All circuit boards are warranted for a period of three (3)
years.
• PC’s and options installed inside the PC are warranted
for a period of three (3) years.
• LCD’s are warranted for a period of three (3) years.
• Power supplies are warranted for a period of three (3)
years.
Hunter Revolution™ Series Tire Changer
Page 11 of 12
To Next Page
Loading...
