SD Card Selection
Memory card is required to operate the camera. When the camera is "ON" and no
memory card is used, the screen displays "No card". The SD slot of the camera has a
32 GB memory capacity. Before inserting or removing the memory card, the camera
must be turned "OFF". Failing to do so may cause loss of or damage the pictures/
videos already recorded on the memory card. When the SD card is full, the screen
shows "Memory Full".
Following data shows an approximate quantity of photos or videos that can be stored
depending on the camera setting and memory card capacity.
USB Connection
When camera is connected via USB cable; screen displays “MSDC”, press “Menu”
once, “MSDC” turns to “PC Cam”, camera can now be used as a PC camera; press
“Menu” again, camera exits PC camera mode.
Attention!
1. Insert the SD memory card correctly, camera doesn’t support hot swap (insertion).
2. Use high-quality AA batteries in order to prevent battery cell corrosion of leaked
acid.
3. Use only original adapter (12V/2A) that is adapted for this camera, and do not
invert the battery polarity in the compartment when putting in the batteries.
4. In Test mode, camera will automatically power off in 3 mins if there is no keypad
touching.
5. Don’t interrupt power supply during firmware upgrade, contact your local dealer for
assistance if the device doesn’t work after upgrading.
6. Do not frequently insert or pull out SD card and battery or plug in and out the
adapter when the camera is ON.
To Next Page
Loading...
