This appliance is for household use
only.
1. Place the fan on a dry, safe, at
surface where it cannot fall or
be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet (or-
dinary household current).
DO NOT use any other type
of outlet. Make sure that the
rated voltage of the fan is the
same as the power source be-
fore plugging it into the power
source.
3. Turn the fan “ON” or “OFF”
by sliding the Power/Speed
Control to the up or down. The
power should always be OFF
before unplugging the fan.
4. To select the speed, move the
Power/Speed Control up from
OFF (O) to the desired speed
setting: Low, Medium. or High.
5. To make the fan oscillate, push
the oscillation pin down. To stop
oscillating, pull the oscillation
pin up.
To Next Page
Loading...
