8
42030-01 • 07/27/11 • Hunter Fan Company
3-1. read the wires from the fan through the canopy cover, canopy,
and downrod and ball assembly.
3-2. Slide the canopy cover over the adapter, then place the canopy on
top of the cover and let them both rest on the fan assembly.
3-3. Loosen the square head setscrew. Screw the downrod into the fan
assembly. Use a wrench or pliers to re-tighten the setscrew.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
WARNING: Do not carry or lift fan by canopy.
3-4. Align the slot on the ball with the tab on the hanger bracket and
place the ball into the hanger bracket.
Go to 4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Canopy
Setscrew
Step 3-4
Tab
Adapter
Slot
Steps 3-1 – 3-3
Downrod
Canopy
Cover
3 • Assembling and Hanging the Fan
To Next Page
Loading...
