41228-01 12/95 - 7 - ©1995 HUNTER FAN CO.™
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE SOLUTION
*NOTE: If blades will not turn by hand, contact your nearest service representative.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will
disappear. If you have checked the above problems and still have trouble, call (901) 745-9222.
1. Nothing happens;
fan does not move.*
2. Noisy operation.
3. Excessive wobbling.
1. Power turned off or fuse blown.
2. Loose wire connections or
wrong connections.
3. Weak battery in transmitter.
4. Transmitter too far from fan.
5. Transmiter/Receiver switches in wrong position.
1. Blade irons loosely screwed to motor.
2. Blade screwed loosely to blade iron.
3. Blade cracked.
4. Light globe noisy.
1. Unbalanced blades.
2. Fan too close to vaulted ceiling.
3. Loose blades or blade brackets.
4. Fan not secure on hanger assembly.
1. Turn power on or replace fuse.
2. Loosen canopy. Check all connections.
(Turn power off while checking.)
3. Install new 9V battery.
4. Maximum range is 15-30 feet.
5. Set switches to matching positions.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace blades.
4. Adjust globe.
1. Use blade balancing kit. (See Step 8D.)
2. Lower or move fan.
3. Tighten all screws.
4. Turn power off. Support fan very carefully.
Loosen canopy and hang correctly.
To Next Page
Loading...
Need help?
General