Hunter TYPE T - Assembling and Hanging the Fan; Standard;Angled Mount Assembly; Low Profile Mount Assembly

6
42765-01•10/05/07•HunterFanCompany
Steps 3-5 – 3-6
Low Profile Screw
Low Profile Washer
Steps 3-2 – 3-3
Downrod
Canopy
Canopy
Trim Ring
Set Screw
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1.Unbundlethewiresfromthefan.
For Standard or Angled mounting:
3-2.Toassemblefantohangdownfromaatorangledceiling,insert
the downrod through the canopy and canopy trim ring. Feed the
wires from the fan through the downrod.
3-3.Loosenthesquareheadsetscrewontheadaptertoinstallthe
pipe and ball assembly. Note: When the pipe and ball assembly
isfullyinstalled,2-3threadsonthepipewillstillbevisible;thisis
normal. Securely retighten the set screw with a wrench or pliers.
SkiptoStep3-7.
CAUTION: e adapter has a special coating on the threads. Do
notremovethiscoating;thecoatingpreventsthedownrodfrom
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the low
profile washer.
3-4. Removethesetscrewfromtheadapter.
3-5.Placethelowprolewasher(lipup)intothecanopy.Besurethe
green ground wire is pointing up toward the ceiling.
3-6.Aligntheholesinthewasherwiththeholesintheadapter.
Assemblesecurelywiththreelowprolescrews.
3-7.Raisethefanandplacethehookontheceilingplatethroughthe
U-shapedholeintherim.
Step 3-7
U-shaped
Hole
3 • Assembling and Hanging the Fan