Hunter TYPE T - Securing Fan to Secondary Support

7
42765-01•10/05/07•HunterFanCompany
4 • Securing Fan to Secondary Support System
4-1. Find the looped end of the braided cable and insert it through the
ceiling plate and one of the holes in the outlet box into the ceiling.
4-2.Accessthesupportbraceintheceiling.Youmaynotbeabletodo
this from below the ceiling depending on your installation site.
4-3.Drivea#10x38mm(1-1/2”)woodscrewandwasherintotheside
ofthebracethatholdstheoutletbox.Leave3mm(1/8”)ofspace
between the support brace and the washer.
4-4. Wrap the braided cable around the support brace once creating a
complete circle.
4-5.Hooktheloopedendofthecableoverthewoodscrewsothatthe
braided cable lies between the washer and the support brace.
4-6. Tighten the loop and secure the screw and washer all the way
down to the support brace.
4-7. Coil up the excess cable.
4-8. Return to the fan so you can complete the fan wiring.
Step 4-1
3mm (1/8")
Steps 4-2 – 4-3
Steps 4-4 – 4-5
Steps 4-6 – 4-7
Support
Brace
Ceiling
Outlet Box
Braided
Cable