Do you have a question about the Hunter Wingate and is the answer not in the manual?
Ensure adequate clearance from blades to walls and floor.
Verify secure mounting to structure or fan-rated outlet box.
For flat ceilings, use a standard downrod.
For angled/vaulted ceilings, use longer downrod and kit.
Secure bracket using provided outlet box screws.
Secure bracket to support structure with wood screws.
Remove setscrew, route wires, hand-tighten downrod, trim wires, and tighten setscrew with pliers.
Slide canopy over wires and place downrod ball into ceiling bracket slot.
Lift fan by housing or downrod to prevent damage.
Connect ceiling, receiver, and fan wires using wire nuts per color code.
Connect all grounding wires securely.
Slide remote receiver into the top of the bracket.
Fit canopy, align holes, and insert canopy screws.
Secure each blade to blade iron with blade nuts and screws.
Partially install screws, align keyhole slots, and tighten securely.
Connect fan and light fixture plugs, ensuring correct color matching.
Align globe retainer notches with light kit tabs.
Attach globe assembly to switch housing using thumbscrews.
Install CR2032 battery, observing polarity and cleaning contacts.
Mount remote transmitter on wall plate with two posts when not in use.
Adjust color temperature (Warm, Cool, Daylight) via remote buttons.
Explains updraft (clockwise) and downdraft (counterclockwise) airflow.
Turn fan off, stop completely, then slide reverse switch.
Check power, breaker, blade spin, and wiring connections.
Ensure blades are installed correctly and hanger ball is seated.
Check blade installation and for cracked blades.
Check battery, install fresh battery, or address multiple remote interference.
Obtain service with proof of purchase; covers motor (lifetime) and parts (one year), with exclusions.
Details exclusions, limitations on implied warranties, and state law variations.
Follow steps 1-5 to remove the standard downrod pipe.
Follow steps 6-10 to reassemble with a new downrod.