8
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Ceiling Bracket Hanging Fan Wiring Blades Light Remote
Fan style may vary.
Note:
Insert the third screw, found in the
hardware bag, into place and
then tighten all three screws.
Partially install two light kit assembly screws,
found in the hardware bag, halfway into
the motor housing as shown. It does not matter
which two screw holes you choose.
Feed the wire plugs through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
Partially install two of the light kit screws
found in the bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
Turn the light kit counterclockwise until the
light kit screws are rmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
1 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
bag
Fan style may vary.
Note:
To Next Page
Loading...
